Suryakanta Objective For determination of moisture content of timber. Reference Standards IS : 1708 (Part 1)-1986 Equipment & Apparatus Balance(0-10 kg) Oven (3000c) Preparation of sample: The dimension of sample to be tested is 2.5 cm in length and 2 x 2 cm or 5 x 5 cm in cross-section. Procedure The sample is weighed (W1) … Read more
Objective For determination of softening point of a given bitumen. Reference Standards IS : 1205-1978-Indian standard methods for testing tar and bituminious materials (Determination of softening point) Equipment & Apparatus Ring and Ball apparatus, Steel balls Brass rings Ball guide Support Thermometer Bath with stirrer Procedure Sample material is heated to a temperature between … Read more
Objective For determination of ductility of distillation residue a given bitumen. Reference Standard IS : 1208-1978- Indian standard methods for testing tar and bituminous materials (Determination of ductility) Equipment & Apparatus Briquette mould, Ductility machine with water bath and a pulling device A putty knife Thermometer Procedure The bitumen sample is maintained to a pouring … Read more
Objective To determinate the penetration of bitumen. Reference Standard IS : 1203-1978-Indian standard methods for testing tar and bituminious materials (Determination of penetration) Equipment & Apparatus Container Needle Stop watch Water bath Penetration apparatus Thermometer Procedure The bitumen is softened to a paving consistency between 750 C and 1000C above the approximate temp … Read more
Objective For determination of Drying shrinkage of Pozzolanic materials. Reference standards IS : 1727- 1967 Methods of test for Pozzolanic : Determination of Drying shrinkage in pozzolana-cement mortar. Equipment & Apparatus Scale Trowel Length Comparator Flow Table Procedure The moulds shall be thinly covered with mineral oil; after this operation the stainless steel or non-corroding metal … Read more
Objective For determination compressive strength of building lime. Reference Standards IS: 6932(Part VII)-Method of tests for Building Limes (Determination of compressive and transverse strengths). Equipment & Apparatus Oven (3000C) Compression testing machine Test Sample Preparation 500 gm of lime is mixed with 60 to 65 % of water for 5 minutes and then the resulting … Read more
Objective For determination of soundness of Build lime by Le-chatelier method Reference Standards IS : 6932(Part IX)-1973-Method of tests for Building Lime (Determination of soundness). Equipment & Apparatus Le-Chatelier apparatus Steam boiler Preparation of sample A suitable amount of hydrated lime is mixed with on third its mass of Portland cement and 4 times its … Read more
Objective For determination of setting time of hydrated lime. Reference Standards IS: 6932(Part 11)-1983-Method of tests for Building Lime (Determination of setting time of hydrated lime) Equipment & Apparatus Balance Burette (50 ml) Enamel tray Vicat apparatus Preparation of sample Lime putty is prepared by thoroughly mixing the 500 gm hydrated lime with an equal … Read more
Objective For determination of Consistency of hydrated lime. Reference Standards IS: 6932(Part 8)-1973-Method of tests for Building Lime (Determination of Consistency of hydrated lime) Equipment & Apparatus Balance Burette (50 ml) Enamel tray Flow table Preparation of sample Lime putty is prepared by thoroughly mixing the 500 gm hydrated lime with an equal mass of … Read more
Objective Determination of Fineness of Building Lime by Dry sieving. Reference Standards IS: 6932(Part IV)-1973-(Methods of tests for Building Lime (Determination of Fineness of Hydrated Lime) Equipment & Apparatus Sieves Oven Balance Preparation sample Test sample is dried in oven for a period of four hours at a temperature of 1000to 1100C. Procedure Sieves specified … Read more