Finishing may be defined as the process of leveling, smoothing, compacting and otherwise treating surface of fresh concrete or recently placed concrete to produce desired appearance. Steps Involved for Finishing Concrete There are 3 different steps involved for finishing concrete, which are as given below. Screeding Floating Trowelling 1. Screeding (Step-1) This is the process … Read more
Removal of Forms Forms should not be removed until the concrete has sufficiently hardened in order that it can carry safely its own weight and any other live loads it is subjected to. The supporting period (period between placing of concrete in forms and removal of forms) differ according to the type of cement used … Read more
Careful supervision during concrete manufacture is necessary for all concreting operations such as batching, mixing, transporting, laying, compacting and curing. While inspecting concreting work following points should be remembered for effective quality control. Inspection during Concreting The concrete mix should be designed in the laboratory with the materials to be used in the field. Weight … Read more
Great care is to be taken to keep the repaired patches moist for several days. In general much amount of care is taken to cure material in patches than the whole structure. The reason is, being relatively small volume of repairs and the tendency of old concrete, around it, to absorb moisture from the new … Read more
This method is used for repairing holes having a depth nearly equal to greater than the least surface dimension, i.e. for any holes and narrow slots cut for the repair of cracks. This method is not used for shallow depressions; for filling patches where reinforcement is exposed or holes which extend through and through wall … Read more
The following 4 mineral admixtures can be used for making concrete. Rice husk ash Metakaolin Silica fume Fly as 1. Rice Husk Ash It is obtained by burning the rice husk in a controlled manner without causing environmental pollution. This is generated in huge quantity in the rice shelters and each tone of paddy produce … Read more
The ultimate bearing capacity of a pile is the maximum load which it can carry without failure or excessive settlement of the ground. The bearing capacity of a pile depends primarily on 3 factors as given below, Type of soil through which pile is embedded Method of pile installation Pile dimension (cross section & length … Read more
Engineering Properties of Soil The following properties of soil are taken into consideration while dealing with soil as a construction material. Cohesion Angle of internal friction Capillarity Permeability Elasticity Compressibility 1. Cohesion It is the internal molecular attraction which resists the rupture or shear of a material. Cohesion is derived in the fine grained soils … Read more
What is Liquid Limit of Soil? When water is added to dry soil, it changes its state of consistency from hard to soft. If we add water to a fine grained soil, then water will change its consistency from hard to semi hard. If we continue to add more water then again the soil will … Read more
This method of rock classification was introduced by Deer & Miller in the year 1996. Two parameters are considered while classifying rocks on this method, which are Uniaxial compressive strength Modulus of elasticity Step by Step Method to Classify Rock Based on Engineering Parameters) This method of rock classification consists of 3 steps, as given … Read more