ABSOLUTE VISCOSITY TEST OF BITUMEN Reference IS: 1206 (Part 2) – Method for Testing Tar and Bitumen Materials: Determination of Absolute Viscosity Test Equipment The following testing equipment is needed to measure absolute viscosity of viscosity graded paving bitumen (IS:73-2006) at 60 C in accordance with IS:1206 (Part 2) (similar to ASTM D 2171), which … Read more
Lab Tests on Bitumen to Check Quality Various tests are conducted on bitumen to assess its consistency, gradation, viscosity, temperature susceptibility, and safety. There are a number of tests to assess the properties of bituminous materials. The following tests are usually conducted to evaluate different properties of bituminous materials. Penetration test Ductility test Softening point … Read more
Determination of Residue of Bitumen Emulsion Purpose This test is done for the determination of residue of bituminous emulsion by sieving through 600-micron is sieve. Apparatus 600 Micron IS Sieve — A circular sieve approximately 100 mm in diameter and 40 mm height. Metal or Glass Dish — A small metal or glass dish about … Read more
Bitumen Content Test of a Bituminous Mix Purpose The test determines the bitumen content in the bituminous mix by cold solvent extraction. Apparatus & Solvent Centrifuge apparatus Trichloroethylene Procedure Take a representative sample of about 500 g, weigh it exactly and place it in the bowl of the extraction apparatus (W1). Cover the sample with … Read more
Test for Bitumen Emulsion: Viscosity by Saybolt Furol Viscometer Purpose Viscosity indicates the resistance to flow due to its internal friction. Higher the viscosity, lower the rate of flow. The test is conducted to see if it is in the specified range. The Test result is expressed in seconds for the flow of 60 cc … Read more
Introduction Specific gravity is defined as the ratio of the mass of a given volume of the bituminous material to the mass of an equal volume of water, the temperature of both being specified as 270C. Apparatus Specific gravity bottle of 50 ml capacity, ordinary capillary type with 6 mm diameter neck or wide mouthed … Read more
Objective For determination of softening point of a given bitumen. Reference Standards IS : 1205-1978-Indian standard methods for testing tar and bituminious materials (Determination of softening point) Equipment & Apparatus Ring and Ball apparatus, Steel balls Brass rings Ball guide Support Thermometer Bath with stirrer Procedure Sample material is heated to a temperature between … Read more
Objective For determination of ductility of distillation residue a given bitumen. Reference Standard IS : 1208-1978- Indian standard methods for testing tar and bituminous materials (Determination of ductility) Equipment & Apparatus Briquette mould, Ductility machine with water bath and a pulling device A putty knife Thermometer Procedure The bitumen sample is maintained to a pouring … Read more
Objective To determinate the penetration of bitumen. Reference Standard IS : 1203-1978-Indian standard methods for testing tar and bituminious materials (Determination of penetration) Equipment & Apparatus Container Needle Stop watch Water bath Penetration apparatus Thermometer Procedure The bitumen is softened to a paving consistency between 750 C and 1000C above the approximate temp … Read more