Slump Cone Test of Fresh Concrete Object This test is performed to measure consistency or workability of fresh concrete, where the nominal maximum size of aggregate does not exceed 38 mm using slump test apparatus. Reference Standards IS : 1199 – 1959 – Method of sampling and analysis of concrete. Equipment & Apparatus Slump cone (Height … Read more
Aim This test method describes the procedure for determining the drying shrinkage or change in length of concrete specimen due to changes in moisture content. Apparatus A length measuring apparatus incorporating a dial gauge capable of measuring the length accurately to 0.005 mm. (see fig shown below) Drying oven capable of maintaining a temperature of … Read more
Factors Affecting Strength Test Results of Concrete Compressive strength is the most important property of concrete. The compressive strength of concrete is determined in the laboratory in controlled conditions. On the basis of this test result we judge the quality of concrete. But sometimes the strength test results vary so widely that it becomes difficult … Read more
Aim To determine volume of concrete per batch, where nominal maximum size of aggregate does not exceed 38 mm. Apparatus Balance – Sensitive to 0.01 kg Tamping bar – Length 38 cm, Weight 1.8 kg Cylindrical mould – Dia = 250 mm, Height = 280 mm, Capacity = 0.01m3 Step by Step Procedure to Calculate … Read more
Sampling of Fresh Concrete To ensure it is representative of the whole truck load, a standard sample consists of scoopfuls taken from different parts of the batch and collected in bucket. Scoopfuls must be taken through the moving stream, as the load is discharged, sampling the whole width and depth (not just the top part). … Read more
Generally we specify workability of concrete in terms of its slump test value. But sometimes it is also specified by another test called compaction factor. The relation between slump and compaction factor is roughly as follows. Relation Between Slump & Compaction factor Workability Slump in mm Compaction factor Very stiff – 0.70 Stiff 0 to … Read more
Objective To measure flow value of concrete using flow table apparatus Equipment Flow table Slump cone shaped mould Wooden tamping bar Procedure Place the flow table on a leveled surface Clean the top of the table and inner surface of the mould using a damp cloth. Place the slump cone centrally on the table. … Read more
Advantages of Slump Test It grants the facility to easily detect the difference in water content of successive batches of concrete of the same identical mix. The apparatus is cheap, portable and convenient to be used at site. Limitation of Slump Test As such, there is no direct relationship between the workability and the value … Read more
Determination of setting time of concrete helps a site engineer in guiding the following areas. Importance of Setting Time of Concrete Whether or not to use any plasticizer To find out effectiveness of set controlling admixture Regulating maximum time of mixing transit, placing and compacting Whether or not to provide protection against adverse weather condition … Read more
The setting time of concrete depends upon following factors, such as Water-cement ratio Temperature condition Type of cement used Use of mineral admixture Use of chemical admixture (such as plasticizer) Other factors which may affect the setting time of concrete includes Absorption of mixing water by aggregates Grinding of aggregates in the mixer Of all … Read more
Subscribe to our mailing list and never miss the latest blog post.
