Codal Provisions from IS 516 (Part 1 / Section 1) If you are involved in construction, quality control, or civil engineering, keeping up with standard codes is crucial for safety and compliance. The Bureau of Indian Standards updated its concrete testing protocols with IS 516 (Part 1 / Section 1): 2021. This comprehensive standard outlines … Read more
On almost every construction project, thousands of concrete cubes or cylinders are cast and tested. Yet obtaining an accurate result involves much more than simply placing a specimen in a compression testing machine. Factors such as specimen preparation, curing conditions, machine calibration, loading rate, and even the exact age of the specimen can significantly influence … Read more
Determine Splitting Tensile Strength of Cylindrical Concrete Specimens Objective: This method covers the determination of the splitting tensile strength of cylindrical concrete specimens Reference: IS: 516 – 1959, IS: 1199-1959, SP: 23-1982, IS: 10086-1982 Theory: Age at Test – Tests shall be made at recognized ages of the test specimens, the most usual being 7 … Read more
FLEXURAL STRENGTH TEST OF CONCRETE Objective To determine the Flexural Strength of Concrete, which comes into play when a road slab with inadequate sub-grade support is subjected to wheel loads and / or there are volume changes due to temperature / shrinking. Reference Standards IS: 516-1959 – Methods of tests for strength of concrete Equipment & … Read more
Making of Test Cubes From Fresh Concrete IS-456 has laid down the acceptance criteria of quality concrete. In all the cases, the 28-days compressive strength shall alone be the criterion for acceptance or rejection of the concrete. 7 days compressive strength of concrete can be carried out in order to get a relatively quicker idea … Read more
Objective To determine the Flexural Strength of Concrete, which comes into play when a road slab with inadequate sub-grade support is subjected to wheel loads and / or there are volume changes due to temperature / shrinking. Reference Standards IS: 516 (Part 1/Sec 1) : 2021 – Hardened Concrete – Methods of Test Part 1: Testing … Read more
Aim This test method describes the procedure for determining the drying shrinkage or change in length of concrete specimen due to changes in moisture content. Apparatus A length measuring apparatus incorporating a dial gauge capable of measuring the length accurately to 0.005 mm. (see fig shown below) Drying oven capable of maintaining a temperature of … Read more
Factors Affecting Strength Test Results of Concrete Compressive strength is the most important property of concrete. The compressive strength of concrete is determined in the laboratory in controlled conditions. On the basis of this test result we judge the quality of concrete. But sometimes the strength test results vary so widely that it becomes difficult … Read more
Capping of Concrete Cylinders Capping is required to give a smooth surface for applying compressive load to concrete cylinders. Only cylindrical concrete test specimens are capped using appropriate method. When the ends of cylindrical test specimens are not plane within 0.05 mm, it is required to cap those test specimens. The capped surfaces should be … Read more
Sampling of Fresh Concrete To ensure it is representative of the whole truck load, a standard sample consists of scoopfuls taken from different parts of the batch and collected in bucket. Scoopfuls must be taken through the moving stream, as the load is discharged, sampling the whole width and depth (not just the top part). … Read more
Subscribe to our mailing list below and never miss the latest blog post.
