DAMPNESS PREVENTION METHODS: The following are the precautions to be taken to prevent dampness in buildings, before applying the various techniques. The site should be located on high ground and well-drained soil to safe guard against foundation dampness All the exposed walls should be of sufficient thickness to safeguard against rain protection (minimum 30 cm) … Read more
PLASTERING The following topics are covered in this post. What is plastering? What are the requirements of good plaster? Different types of mortars for plastering Number of coats of plastering How to preparation of background before plastering? What are the recommended mortars mixes for different situation? What are the defects in plastering? What is plastering? … Read more
TYPES OF DEFECTS IN PLASTER This post describes 7 different categories of defects most frequently noticed in plaster (as mentioned below) Non-structural cracks Structural cracks Debonding Lack of hardness Grinning Expansion Popping The causes and repair methods for each are discussed below. 1. Non-structural cracks Crazing is a network of fine cracks, usually in a … Read more
Requirements of Good Stairs A good stair should provide an easy, quick and safe mode of communication between the various floors of the building. General requirements of good stairs are as mentioned below. 1. Location It should preferably be located centrally, ensuring sufficient light and ventilation. 2. Width of Stair The width of stairs for … Read more
DEFECTS IN BRICKWORK EFFECTS OF WORKMANSHIP ON MASONRY STRENGTH Masonry has a very long tradition of building by craftsmen, without engineering supervision of the kind applied to reinforced concrete construction. Consequently, it is frequently regarded with some suspicion as a structural material and carries very much higher safety factors than concrete. There is, of course, … Read more
Quality Control in Concrete Construction Quality of concrete construction on site can be accomplished in three distinct stages as follow Quality control before concreting Quality control during concreting Quality control after construction Stage-1 (Quality Control Before Concreting) This stage of quality control consists of two steps. Checking of specification requirements regarding excavation, forms, reinforcement and … Read more
Technical Properties of Mortar For the sake of projects, the newly mixed mortar should have good workability, and the hardened mortar should have the required strength, the bending power to the bottom face, little deformation and durability. 1. Workability of Fresh Mortar The workability of fresh mortar refers to the comprehensive properties of mortar easy … Read more
The Basic Properties of Heat-insulating Material In architecture, the material which prevents the outflow of indoor heat is normally called adiabator. On the other hand, the material which prevents the inflow of outdoor heat is called heat insulator. These two are collectively called heat-insulating materials. This kind of material is mainly used for walls, ceilings, … Read more
1. STORING OF BRICKS ON SITE Stacking and Storing of Bricks at Site Stack the bricks close to the site of work so that less effort is required to unload and transport the bricks again by loading on pallets or in barrows. Different types of bricks (such as clay bricks, clay fly ash bricks etc.) … Read more
Protection of Masonry During Construction It is necessary to protect masonry during construction when the mortar is green or when masonry has not been laterally supported, against damage due to rain, frost, storm, etc. It is also necessary to protect some vulnerable parts of masonry such as jambs, corners and sills and expose masonry, during … Read more